Telexforum.de

If this post is in the wrong place, please excuse me. Does anyone have a stand they would like to sell? If not, could someone provide the dimensions or q drawing so that I can try to build something that would work? I currently have the machine on a low table, but it is very difficult to type this way.

Thank you.

Hi Paul,

as I recall, for your "export version T100" only the matching stand fits which will be only available in Austria.

But I will have a look at my Austrian T100S to see if it also has got the holes in the base that you need to fit also for a German stand.

Henning

Hello Paul,

here are the dimensions of a Siemens table for my T100 (without "S"), but my T100 is in the same green case as many "green "T100S.

This stand with a wooden base board would work also for the "Export" model as you use
it as a simple desk.

There are two holes at the rear side .....

The holes are for the cables to get them out of the noise cancelling cover.
The wooden board is for the noise cancelling cover. For "normal" operation without noise cancelling
the stand fits directly to a blue T100/T100S.

The stand for the export version case is different. But it might be also only a form design issue.
With a board it fits for sure.

Thank you, Franz and Henning. This is very helpful.