Telexforum.de

Files for all card handles usually needed for I-Telex

Dear Sean,

Thanks for the effort!
Some pictures would be nice if there are 3D items.
"one picture says more than 1000 words", as my grandfather used to say

I will add pictures once they are installed

3D printing is a new technology for me, so I am sure some of you with lots of experience will be able to produce more professional results

Here is an image, showing the handles attached to the front panels.

Some adjustment work will be needed for the handle covers the tolerance is a little tight - this is easily done with some sand paper.

Others more experienced with 3D printing might get better results.

More about the front panels in another post